IRUS I104 Assembly Instructions

assembly instructions

for the exhibition stand I104

constisting of:

- 6x Aluminium profile à 1250 mm incl. bores

- 6x Aluminium profile à 1250 mm incl. adjustable foot and bores

- 10x Aluminium cross profile with pointed screws for the lower and upper mounting

- 20x H-Profiles à 1217mm to stabilize the panels.

- 6x Extension bolt for aluminium profile

- 3x longarm lighting 450mm incl. replacement bulb

10x

System

exhibition

20x

Table of Contents

Need help?

Do you have a question about the I104 and is the answer not in the manual?

Page 1 System ® for the exhibition stand I104 exhibition constisting of: - 6x Aluminium profile à 1250 mm incl. bores - 6x Aluminium profile à 1250 mm incl. adjustable foot and bores - 10x Aluminium cross profile with pointed screws for the lower and upper mounting - 20x H-Profiles à...
Page 2 System ® exhibition Important during assembly Pointed screws must be used for all profiles that have holes. 1. Mounting the lower area of the 2. Slide the upper profiles over the corner with the aluminium cross extension bolts. Make sure that profile incl.
Page 3 System ® exhibition 5. Insert the remaining extension bolts and 6. Now mount the remaining upper slide the remaining upper profiles over aluminium cross profile incl. the extension bolts. Make sure that the pointed screws. boreholes are upwards. 7. Fully assembled exhibition stand. If necessary, compensate for uneven floors with the leveling feet.