IRUS I108 Assembly Instructions

Exhibition stand

assembly instructions

for the exhibition stand I108

constisting of:

- 8x Aluminium profile à 1250 mm incl. bores

- 8x Aluminium profile à 1250 mm incl. adjustable foot and bores

- 14x Aluminium cross profile with pointed screws for the lower and upper mounting

- 7x Aluminium cross profile for the middle mounting

- 28x H-Profiles à 1200mm to stabilize the panels

- 8x Extension bolt for aluminium profile

- 3x longarm lighting 450mm incl. replacement bulb

28x

System

14x

exhibition

Table of Contents

Need help?

Do you have a question about the I108 and is the answer not in the manual?

Page 1 System ® for the exhibition stand I108 exhibition constisting of: - 8x Aluminium profile à 1250 mm incl. bores - 8x Aluminium profile à 1250 mm incl. adjustable foot and bores - 14x Aluminium cross profile with pointed screws for the lower and upper mounting - 7x Aluminium cross profile for the middle mounting - 28x H-Profiles à...
Page 2 System ® exhibition Important during assembly Pointed screws must be used for all profiles that have holes. 1. Mounting the lower area of the 2. Then mount the middle cross corner with the aluminium cross aluminium profile. profile incl. pointed screws. 4.
Page 3 System ® exhibition 5. Slide the upper profiles over the 6. Then mount the remaining upper extension bolts. Make sure that cross aluminium profile. the boreholes are upwards. 7. Fully assembled exhibition stand. If necessary, compensate for uneven floors with the leveling feet.