Advertisement
Table of Contents
assembly instructions
for the exhibition stand I110
constisting of:
- 8x Aluminium profile à 1250 mm incl. bores
- 8x Aluminium profile à 1250 mm incl. adjustable foot and bores
- 2x Aluminium profile à 300 mm incl. 8 bores for aperture
- 14x Aluminium cross profile with pointed screws for the lower and upper mounting
- 7x Aluminium cross profile for the middle mounting
- 6x Aluminium cross profile with pointed screws for aperture
- 28x H-Profiles à 1200mm to stabilize the panels
- 8x Extension bolt for aluminium profile
- 3x longarm lighting 450mm incl. replacement bulb
8x
7x
8x
8x
6x
System
14x
2x
28x
3x
®
exhibition
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for IRUS I110
Summary of Contents for IRUS I110
- Page 1 System ® for the exhibition stand I110 exhibition constisting of: - 8x Aluminium profile à 1250 mm incl. bores - 8x Aluminium profile à 1250 mm incl. adjustable foot and bores - 2x Aluminium profile à 300 mm incl. 8 bores for aperture...
- Page 2 System ® exhibition Important during assembly Pointed screws must be used for all profiles that have holes. 1. Mounting the lower area of the 2. Then mount the middle cross corner with the aluminium cross aluminium profile. profile incl. pointed screws. 4.
- Page 3 System ® exhibition 5. Slide the upper profiles over the extension 6. Then mount the remaining upper bolts. Make sure that the boreholes are cross aluminium profile. upwards. 8. Fully assembled exhibition stand. 7. Then mount the aperture. If necessary, compensate for uneven floors with the leveling feet.
Need help?
Do you have a question about the I110 and is the answer not in the manual?
Questions and answers