Bin Control Check - Hoshizaki KM-150BAF-E Installation Manual

7. START-UP 7. START-UP
7. START-UP 7. START-UP 7. START-UP
1. This icemaker is designed to produce edible
ice. To keep the icemaker sanitary:
• Wash your hands before removing ice.
• Use the Plastic Scoop provided (acces-
sory).
• Keep the Scoop clean. Clean it by using a
neutral cleaner and rinsing thoroughly.
• The Storage Bin is for ice use only. Do not
store anything else in the Bin.
• Close the Door after removing ice to prevent
entrance of dirt, dust or insects into the
Storage Bin.
2. The use of any electrical equipment
involves the observance of some
fundamental rules. In particular:
• Instances of high humidity and moisture
increase the risk of electrical short circuits
and potential electrical shocks. If in doubt,
disconnect the icemaker.
• Do not use the icemaker when you have
bare feet.
• Do not pull the electricity supply wire in
order to disconnect the icemaker from the
feed network.
• This appliance is not suitable for unsuper-
vised use by young children or aged or
infirm persons.
3. All parts are factory-adjusted.
adjustments may result in failure.
4. If the unit is turned off, wait for at least 3
minutes before restarting the icemaker to
prevent damage to the Compressor.
5. Do not operate the unit in the "WASH" posi-
tion without water in the Water Tank. This
will cause damage to the Water Pump seal.
1) Open the Water Supply Line Shut-off Valve.
2) Remove the Front Panel.
3) Move the Control Switch, on the Control Box, to the
"ICE" position.
4) Replace the Front Panel in its correct position.
5) Turn on the power supply and allow the Water Tank
to fill with water and the icemaker to operate for a
total of 10 minutes. (See 8 for Sequence of Opera-
tion).
91U1TB10A9907
WARNING WARNING WARNING WARNING WARNING
Improper
6) Turn off the power supply, and open the Bin Door.
7) Remove the Cube Guide and the Overflow Pipe to
drain the Water Tank (See Fig. 2).
8) Replace the Overflow Pipe and the Cube Guide in
their correct positions.
9) Clean the Storage Bin.
10) Shut the Bin Door.
11) Turn on the power supply, and start the automatic
icemaking process.
12) Wait until a complete icemaking and defrost cycle
is completed.

BIN CONTROL CHECK

BIN CONTROL CHECK BIN CONTROL CHECK BIN CONTROL CHECK BIN CONTROL CHECK
1) Open the Bin Door.
2) Hold some ice against the Bin Control Bulb. The
icemaker should stop within 6 to 10 seconds.
3) Close the Bin Door.
4) Check that the icemaker re-starts.
5
ENGLISH
Fig. 3 Fig. 3 Fig. 3 Fig. 3 Fig. 3