Cisco Catalyst 2950 Software Manual page 348

Table A-1 Common ACL Error Messages (continued)
Error Message
%Error:Access Group is not supported on
EtherChannel interface
%Error:A MAC Access Group exists on this
interface
%Error:An IP Access Group exists on this
interface
%Error:Out of Rule Resources
%Error:No free rules on this interface
%Error:ASIC error
%Error:ASIC out of resources
%Error:Mask/rule entry failure, errcode=XX
%Error:FAILURE to reinsert old ACL
%Error:Max limit reached for number of ACEs in
ACL :<acl_name>
%Error:access-list too large to support on
this interface
%Error:FAILURE to reinsert old ACL, errcode=XX
%Error:Egress port invalid
%Error:The field sets of all the ACEs in an
ACL should match
Catalyst 2950 Desktop Switch Software Configuration Guide
A-4
Appendix A
Explanation and Suggested Solution
This error message means that an access group is applied on an
EtherChannel interface.
Access groups can be applied only to Layer 2 physical interfaces or
management VLANs.
This error means that a MAC access group was previously configured
on this interface.
Delete the MAC access group by using the no mac access-group
interface configuration command, and re-enter the ip access-group
interface configuration command.
This error means that an IP access group was previously configured
on this interface.
Delete the IP access group by using the no ip access-group interface
configuration command, and re-enter the mac access-group interface
configuration command.
This error means that the hardware has run of resources.
Re-enter the command with fewer ACEs.
This error means that the hardware has run out of resources.
Re-enter the command with fewer ACEs.
This error means that the hardware has returned an error and that the
command cannot be completed.
This error message means that the hardware does not have sufficient
resources to support the user policies.
This error means that the hardware displays an unknown error with the
specified error code.
This error means a hardware failure.
Delete the access group, and re-enter the command.
The maximum limit for the number of ACEs in an ACL is reached.
The ACE can not be added to the ACL.
The access list can not be applied on this interface because the
interface does not have sufficient resources to meet the requirement of
this access list. Re-enter the command with fewer ACEs.
This error means a hardware failure.
Delete the access group, and re-enter the command.
This error message means that an invalid egress port was detected by
the hardware. Re-enter the command for the interface.
All the ACEs in an ACL must have the same mask. Change the ACE
to have the same mask as the other ACEs in the ACL.
Error Messages for Security and QoS Configurations
78-11380-03