Cisco Catalyst 2950 Software Manual page 196

Load Sharing Using STP
Command
Step 4
exit
Step 5
show vtp status
Step 6 show vlan
Step 7 configure terminal
Step 8
interface
fastethernet0/1
Step 9
switchport mode
trunk
Step 10
end
Step 11 show interface
fastethernet0/1
switchport
Step 12
Step 13
Step 14 show vlan
Step 15 configure terminal
Step 16
interface
fastethernet0/1
Step 17
spanning-tree vlan 8
port-priority 10
Step 18
spanning-tree vlan 9
port-priority 10
Step 19
spanning-tree vlan
10 port-priority 10
Step 20
end
Step 21 interface
fastethernet0/2
Step 22 spanning-tree vlan 3
port priority 10
Step 23 spanning-tree vlan 4
port priority 10
Step 24 spanning-tree vlan 5
port priority 10
Step 25 spanning-tree vlan 6
port priority 10
Step 26 exit
Step 27
show running-config Verify your entries.
Catalyst 2950 Desktop Switch Software Configuration Guide
8-26
Purpose
Return to privileged EXEC mode.
Verify the VTP configuration on both Switch 1 and Switch 2.
In the display, check the VTP Operating Mode and the VTP Domain Name
fields.
Verify that the VLANs exist in the database on Switch 1.
Enter global configuration mode.
Enter interface configuration mode, and define fastethernet 0/1 as the interface
to be configured as a trunk.
Configure the port as a trunk port.
Return to privileged EXEC mode.
Verify the VLAN configuration.
Repeat Steps 7 through 11 on Switch 1 for interface fastethernet 0/2.
Repeat Steps 7 through 11 on Switch 2 to configure the trunk ports on interface
fastethernet 0/1 and fastethernet 0/2.
When the trunk links come up, VTP passes the VTP and VLAN information
to Switch 2. Verify the Switch 2 has learned the VLAN configuration.
Enter global configuration mode on Switch 1.
Enter interface configuration mode, and define the interface to set the STP port
priority.
Assign the port priority of 10 for VLAN 8.
Assign the port priority of 10 for VLAN 9.
Assign the port priority of 10 for VLAN 10.
Return to global configuration mode.
Enter interface configuration mode, and define the interface to set the STP port
priority.
Assign the port priority of 10 for VLAN 3.
Assign the port priority of 10 for VLAN 4.
Assign the port priority of 10 for VLAN 5.
Assign the port priority of 10 for VLAN 6.
Return to privileged EXEC mode.
Chapter 8 Configuring VLANs
78-11380-03