Cisco Catalyst 2950 Software Manual page 305

Desktop switch software configuration guide
Hide thumbs Also See for Catalyst 2950:
Table of Contents

Advertisement

Configuring
This chapter describes how to configure quality of service (QoS) on your switch. With this feature, you
can provide preferential treatment to certain types of traffic. Without QoS, the switch offers best-effort
service to each packet, regardless of the packet contents or size. It transmits the packets without any
assurance of reliability, delay bounds, or throughput.
To use the features described in this chapter, you must have the enhanced software image installed on
your switch.
If you have the standard software image installed on your switch, you cannot configure some of the
features.
Table 13-1 Sections Describing Standard-Software Features
Topic
Queueing and scheduling at
the egress ports
Configuring QoS
For complete syntax and usage information for the commands used in this chapter, refer to the
Note
Catalyst 2950 Desktop Switch Command Reference for this release.
QoS can be configured either by using the Cluster Management Suite (CMS) or through the
command-line interface (CLI). Refer to the CMS online help for step-by-step configuration procedures
through CMS. For information about accessing and using CMS, see the
section on page
78-11380-03
QoS
Table 13-1
lists the sections that describe the features that you can configure.
Section
"Queueing and Scheduling" section on page
"Configuring QoS" section on page
"Default QoS Configuration" section on page
"Configuring the CoS Value for an Interface" section on
page
"Configuring CoS and WRR" section on page
2-1.
C H A P T E R
13-13.
Catalyst 2950 Desktop Switch Software Configuration Guide
13
13-8.
13-9.
13-9.
13-23.
"Getting Started with CMS"
13-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents