Mafell DDF40 Operating/Safety Instructions Manual page 23

DDF40
Use the following procedure to remove the roller
edge guide from the lateral guide fence:
1. Turn the lever (20) to position "1".
Take note of the icons on the roller edge
➢
guide.
2. Push the roller edge guide forward and remove
it.
Roller edge guide removed from the lateral
✓
guide fence.
5.4.2 Drilling with batten guide fence U.S.A.
The batten guide fence is used for drilling into narrow battens (approx. 14 - 48 mm | 0.55 - 1.89 in) and small
distances between drilled holes.
Important information when using the batten guide fence:
- You may only use 1 drill bit with max. ø 8 mm [0.31 in].
- Unused drill bits must be removed from the machine beforehand.
- The drill spacing to the stop pin is 7.5 mm! [0.30 in]
- When you adjust the drilling depth, bear in mind that the batten guide fence reduces it by
15 mm [0.59 in].
Use the following procedure to install the batten
guide fence:
1. Ensure that only one drill bit with max. ø 8 mm
[0.31 in] is mounted in the machine.
2. Press the catches (23) on the batten guide
fence together and insert the batten guide fence
at the front of the base plate.
The batten guide fence can only be
➢
mounted in the correct position with
respect to the mounted drill bit!
Batten guide fence mounted.
✓
01/2022
Fig. 23: Removing the roller edge guide from the lateral
guide fence
Fig. 24: Mounting the batten guide fence on the machine
23