General Assembly Instructions; Dry Vacuum Operation - Vacmaster VOC508S Operator's Manual

GENERAL ASSEMBLY INSTRUCTIONS

A Philips head screw driver is required.
1
1. Remove the two provided screws from the handle. Insert the handle of ash tank into the slots
located on the top of the tank cover and secure it with the screws as shown. Do not over-
tighten screws (Fig. 1 & 2).
2. Clip the ash filter onto the underside of the ash tank hose port with two fixed clips, and rotate
the third movable clip to secure in place (Fig. 3).
3. Place the tank cover on the tank and secure into place using the latches (Fig. 4).

DRY VACUUM OPERATION

1
5
Connection Port
for the Hose of
Vacuum Cleaner
DRY VACUUMING
WARNING:
IS DESIGNED TO COLLECT COLD ASH OR COARSE RESIDUAL MATERIAL FROM
FIREPLACES, PELLET STOVES, AND GRILLS.
NOTE: THIS ASH TANK IS DESIGNED TO BE USED TO IN CONJUNCTION WITH THE
VACUUM CLEANER.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Insert the locking end of the ash tank hose into the ash tank hose port and turn it clockwise to
secure (Fig. 2).
3. Insert the aluminum wand into the end of the ash tank hose (Fig. 3).
4. Insert the locking end of the wet/dry vac hose into the vacuum port on the collection tank and
lock into place (Fig. 4).
3
2
2
3
6
WHEN CONNECTED TO A VACUUM CLEANER, THIS ASH TANK
4
Clip
4
7 8
23