Removal And Replacement Of Auger - Hoshizaki DT-400BAH-OS Service Manual

5) Place the new extruding head in place.
6) Replace the removed parts in the reverse order of which they were removed.
7) Replace the refrigeration tray in reverse order from which it was removed.
1. When reinstalling the refrigeration tray, make sure the drain hoses align
properly over the drain tank in the rear of the machine. See Fig. .
. Make sure wiring is properly secured by the wire saddle and clear of the fan
blade.
8) Replace the lower cabinet stand panel in its correct position.
9) Plug the icemaker back in. Move the control switch to the "ICE" position to start the
automatic icemaking process.

3. Removal and Replacement of Auger

1) Move the control switch to the "DRAIN" position and drain all of the water from the
evaporator.
) After the water has stopped draining, remove the refrigeration tray as outlined in
"V.C. Removal of Refrigeration Tray."
3) Remove the allen head cap screws and lift off the auger sleeve. Using the auger cap,
lift out the auger assembly. See Fig. 3.
4) Remove the auger cap and extruding head from the auger and place them on the new
auger.
5) Install the new auger.
6) Replace the removed parts in the reverse order of which they were removed.
7) Replace the refrigeration tray in the reverse order of which it was removed.
1. When reinstalling the refrigeration tray, make sure the drain hoses align
properly over the drain tank in the rear of the machine. See Fig. .
. Make sure wiring is properly secured by the wire saddle and clear of the fan
blade.
8) Replace the lower front panel in its correct position.
9) Plug the icemaker back in. Move the control switch to the "ICE" position to start the
automatic icemaking process.
CAUTION
CAUTION
46