Table of Contents
Advertisement
G. Removal and Replacement of Fan Motor
1) Move the control switch to the "OFF" position.
) Unplug the icemaker from the electrical outlet.
3) Remove the lower cabinet stand panel.
4) Slide the refrigeration circuit tray forward as described below. See Fig. 3.
a) Remove the screw and L-bracket at the base of the tray.
b) Move the inlet reservoir hose coming into the top of the reservoir to the side.
c) Slide the refrigeration tray forward to the limit allowed by the transport hose sliding in
the channel above. Support the front end of the refrigeration tray.
5) Disconnect the wire connectors from the fan motor leads.
6) Remove the fan motor bracket.
7) Remove the fan blade and install on the new fan motor.
8) Install the new fan motor on the fan motor bracket.
9) Replace the fan motor bracket in its correct position and reconnect the wire connectors.
10) Slide the refrigeration circuit tray back into position.
11) Realign the inlet reservoir hose.
1. When reinstalling the refrigeration tray, make sure the drain hoses align
properly over the drain tank in the rear of the machine. See Fig. .
. Make sure wiring is properly secured by the wire saddle and clear of the fan
blade.
1) Replace the lower cabinet stand panel in its correct position.
13) Plug the icemaker back in. Move the control switch to the "ICE" position to start the
automatic icemaking process.
H. Removal and Replacement of Control or Dispensing Water Valve
1) Close the water supply line shut-off valve.
) Open the water supply line drain valve.
3) Move the control switch to the "OFF" position.
4) Unplug the icemaker from the electrical outlet.
5) For the control water valve, remove the lower front panel. For the dispensing water
valve, remove the upper front panel.
6) Disconnect the wire terminals from the water valve.
7) Loosen the fitting nut on the water valve. Do not lose the washer inside the fitting nut.
8) Remove the water valve bracket.
CAUTION
50
Advertisement
Table of Contents
