Table of Contents
Advertisement
14) Replace the refrigeration tray in the reverse order of which it was removed.
1. When reinstalling the refrigeration tray, make sure the drain hoses align
properly over the drain tank in the rear of the machine. See Fig. .
. Make sure wiring is properly secured by the wire saddle and clear of the fan
blade.
15) Replace the lower front panel in its correct position.
16) Plug the icemaker back in. Move the control switch to the "ICE" position to start the
automatic icemaking process.
6. Removal and Replacement of Gear Motor
1) Move the control switch to the "DRAIN" position and drain all of the water from the
evaporator.
) After the water has stopped draining, remove the refrigeration tray as outlined in
"V.C. Removal of Refrigeration Tray."
3) Remove the bolts securing the lower housing to the gear motor. Lift the evaporator up
slightly.
4) Remove the bolts securing the gear motor drain pan.
5) Disconnect the wiring from the gear motor, then remove the
gear motor and gear motor drain pan.
6) Remove the spline coupling from the old gear motor and
attach to the new gear motor.
7) Remove the old gear motor from the drain pan, install the
new gear motor to the drain pan.
8) Attach the gear motor drain pan (with gear motor) to the
base.
9) Replace the removed parts in the reverse order of which
they were removed.
10) Replace the refrigeration tray in reverse order from which it was removed.
1. When reinstalling the refrigeration tray, make sure the drain hoses align
properly over the drain tank in the rear of the machine. See Fig. .
. Make sure wiring is properly secured by the wire saddle and clear of the fan
blade.
11) Replace the lower front panel in its correct position.
1) Plug the icemaker back in. Move the control switch to the "ICE" position to start the
automatic icemaking process.
CAUTION
CAUTION
49
Gear Motor
Drain Pan
(Bolts)
Gear Motor Bolts
Base
Fig. 5
Advertisement
Table of Contents
