Removing The Device From The Operating Buttons - Delete Function - fakro AMZ User Manual

Device programming
Removing the device from the operating buttons – DELETE
function.
In some cases (change of place of installation, replacement of
damaged equipment), it is necessary to remove the device from the
operating buttons (DELETE) as well as from the network (EXCLUDE) to
prevent errors when sending commands (to non-existent devices) and
excessive drain on the batteries of portable controllers.
devices physically from the network without first removing them
from the memory controller by using the DELETE and EXCLUDE
functions
It can lead to considerable delays in the operation of
devices in the network and the rapid wear on the batteries of portable
controllers. The order of execution of the function is also very important.
First, perform the DELETE function and at the very end the EXCLUDE
function. Please find below exemplary procedure of removing the
device from the operating buttons.
1 . By pressing button choose one of four channels which will be used
for programming the blind and then...
Within 1 second press the sequence of buttons:
2. Press the In/Ex twice and then...
3. Press one of the operating buttons
4. Readiness to remove the device is signalled by the controller
– LEDs 2,3,4 light up for 1 0 sec.
5. Press the programming button on the awning blind for 1 sec.
6. The controller signals:
correct removing of the assigning is signalled by the controller –
LEDs 1 ,2,3 light up for 2 sec.
incorrect removing of the assigning – LEDs 2,3,4 blink three times.
9/1 6
Do not remove
or or
2 3 4
1
IN/EX
x2
t<1sec.
x1
2 3 4
x1
2 3
2 3
1
4
9/1 6