Operation Mode And Automatic Control; Modes Of The Awning Blind Operation; Change Of Parameters; Opening Or Closing Time In A And S Mode - fakro AMZ User Manual

Operation mode and automatic control

Mode of the awning blind operation
In automatic control the solar blind utilizes 2 sensors: solar
radiation and temperature. Solar radiation sensor is realized by measuring
the voltage from photovoltaic panel and has direct influence on the awning
blind unrolling and rolling up.
Temperature sensor influences mode of the awning blind operation –
summer or winter. The awning blind works in summer mode when the
temperature is above 0 °C and in winter mode below this temperature. In
summer mode after exceeding set value of insolation (default 60%) the
awning blind automatically unrolls. Below this value (e.g. permanent
cloudiness) it rolls up. If the awning blind is below a certain min. insolation
level (during the night) it unrolls.
When setting semi-automatic control mode the awning blind can be
open for a few minutes depending on a set time (default 3 min.). In winter
mode the awning blind opens for a day and closes during a night, thus
contributing to solar energy gains.
In manual control mode the awning blind is unrolled and rolled up
with the use of the remote control buttons.
NOTE
When changing parameters watch carefully signalling LEDs.
Correct setting of the parameters is signalled by a single blink of LED of
the chosen level. Incorrect setting of the parameters is signalled with three
blinks of the chosen level.

Change of parameters

Opening or closing time in A and S mode

Change of default opening/closing time of the blind (3 min.) in
semi-automatic control mode is realized by M and UP/DOWN buttons. It is
possible to choose 1 ,2,3 or 4 LEDs corresponding to 3,4,5 or 6 minutes.
1 . Press and hold M button and then...
2. By pressing one of the controlling buttons
requested value.
3. Release M button.

Insolation level

Change of default insolation level (60%) at which opening or
closing of the blind is realized with the use of S and UP/DOWN buttons.
It is possible to set 50%, 60%, 70%, 80%
1 . Press and hold S button and then...
2. By pressing one of the operating buttons
requested value
3. Release S button

Change of work modes

To choose 2 modes of work – (1 ) SUMMER/WINTER and (2)
SUMMER. Mode no. 1 of work is default. In order to change mode of work
it is necessary to press A and UP/DOWN buttons.
1 . Press button A and then...
2. By pressing one of the operating buttons
requested value
3. Release A button
2
2
or or choose
2
2
or or choose
2
2
or or choose
2 3 4
1
1
2 3 4
1
1
2
1
1
1 3/1 6