Table of Contents
Advertisement
KNIFE MAINTENANCE
Remove bolt A and nut B. Open the upper housing toward the discharge pipe. Lock the knife disk during maintenance.
Turn the knife disk until the hole in the disk is aligned with locking pin D. Remove locking pin circlip C and push the
pin into the hole in the disk. Lock the pin with the circlip.
Remove knife bolts E (4 pcs), nuts F (4 pcs) and lock washers G (4 pcs). Remove knife H. Sharpen or replace the
knife. Mount the knife with bolts, lock washers and nuts. Sharpen knives in pairs to keep lengths the same and maintain
disk balance.
64
CH27 ACR & ACC
Advertisement
Table of Contents
