Deleting Vrrp Configurations - Nokia Check Point IP2450 Installation Manual

Configuring Check Point IPSO for IP2450 ADP Interfaces
The following figure shows the VRRP configuration:
The rest of this section describes how to reconfigure the interfaces and VRRP to accommodate
the ADP interfaces.

Deleting VRRP Configurations

After you physically remove PMC NIC card carriers that you are replacing with ADP modules,
you need to delete the configuration information for those interfaces. If VRRP is active at that
time, you will not be able to delete the configuration information for the interfaces used by
VRRP. Therefore, you should begin by deleting the existing VRRP configuration.
Note
It is best to perform the procedures in this section on the VRRP backup system first. When
the installation is complete, the upgraded system can become the new master while you
upgrade the original master.
Check Point IP2450 Security Platform Installation Guide 79