Installation - HAMPTON BAY 504081010 Use And Care Manual

Installation

WARNING: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off
the circuit breaker before removing the existing light fixture or installing the new one.
With power disconnected to the electrical box, remove the existing fixture. Make a sketch of how the current fixture is wired (by wire color)
or mark the wires with masking tape and a pencil so you will know how to properly reconnect the wires to the new LED light fixture.
1
Adjusting the Color Temperature of
the Light
□ Remove the rubber plug and using a philips head screw
driver access the color temperature setting switch cover.
□ Choose color temperature (CCT) from three options: 2700k
Warm White, 3000k Soft White, or 4000k Bright White.
NOTICE: The factory setting for the correlated color
temperature (CCT) is 2700K.
□ Install the color switch cover, then fix the screw with a
philips head screw driver and replace rubber plug
2700K 3000K 4000K
3
Making the electrical connections
□ Connect the hot and neutral (black and white) wires from the
fixture body (A) to the same color wires from the electrical box.
□ Cover the wire connectors (CC) with electrical tape for a more
secure connection.
□ Position the wires back inside the electrical box.
4
Attaching the fixture
□ Align the side slots on the fixture body (A) with the mounting
bracket (AA) and fix the fixture body (A) securely by carefully
rotating in clockwise the side slots inside the mounting
bracket (AA).
A
Switch cover
Rubber plug
2
Fixing the bracket (AA)
□ Pass the hot and neutral (black and white) wires from
the electrical outlet box through the middle hole of the
mounting bracket (AA).
□ Align the mounting bracket (AA) using the mounting screws
(BB) and tighten securely to the electrical box.
BB
A
Side slot
A
AA
4
AA
CC
AA