Removable Brushes - Hoover F7412900 Owner's Manual

Instrucciones de Funcionamiento y Servicio
Por favor, lea este manual antes de hacer funcionar su producto Hoover®.
©2008 Healthy Gain Investments, Ltd. Todos los derechos reservados. N°56518217. 6/08
Manual del Propietario
www.hoover.com
Aspiradora para
alfombras Dual V™
To clean nozzle
If lint or other
3.9
debris becomes
lodged in nozzle, it
can be removed for
cleaning.
Unplug cleaner from
electrical outlet.
Remove both tanks
as described in
Figs. 2.9- 2.10.
With handle in
Lift up rear edge of
upright position,
nozzle. Slide nozzle
tilt cleaner back so
up and remove
that handle rests on
from cleaner.
the floor.

Removable brushes

Your cleaner is equipped with removable
brushes. Follow these directions for chang-
ing brush assemblies or for easy cleaning.
To remove brushes
Disconnect cleaner from electrical outlet.
To prevent possible leaking, remove clean
water tank and recovery tank. Set tanks
aside.
To replace brushes
Align posts (A) on both ends of brush assem-
bly with slots (B) in cleaner housing.
Make sure that the square post (C) also aligns
with the square hole (D). Turn brushes slightly
until post fits easily into hole.
Press brush assembly firmly to snap into
place.
Slide nozzle com-
3.10
pletely onto clean-
er. Press down on
nozzle to secure it.
Replace recovery
tank (Fig. 2-21).
B
The nozzle must be
A
in the proper posi-
tion in order for
the recovery tank
to go on properly.
To replace nozzle,
line up tabs (A) on
nozzle with holes
(B) in cleaner. Slide
tabs into holes.
With handle in
3.11
upright position,
tilt cleaner back
until handle rests
on the floor.
Grab brush assem-
bly and pull firmly.
The brushes can be
cleaned under run-
ning water.
B
3.12
D
B
A
C
17 www.hoover.com
A