EA Technology CableData CDC3 Operating Manual page 3

3660-MANUL-V01.01.00-CDC3 Operating Manual
Safety Precautions and procedures
The CableData
• ®
EA Technology Ltd. Misuse of the equipment can result in injury or death.
Ensure relevant safety notes and manuals from any auxiliary equipment and sensors such as that
•
from the HFCT are read in conjunction with this manual.
The CDC can be used without de-energizing the local equipment, it must be considered under the
•
relevant risk assessment.
• The CDC is designed for use at ground potential only.
• When testing electrical plant ensure metalwork is earthed before observing measurements.
• Local safety procedures and guidelines (including the use of personal protective equipment) must be
followed during the installation and use.
• Maintain safety clearances between structures at high voltage and the instrument, its probes, and the
operator always.
• Do not make measurements with electrical storms in the vicinity.
• Do not make measurements immediately following the energization of a circuit.
Do not disturb the plant during measurements either mechanically (e.g., shaking or striking it),
•
electrically (e.g., increasing the voltage) or physically (e.g., applying heat).
Do not operate the CDC or any accessories in an explosive environment.
•
Before installation and use, always check the condition of the connecting cables.
•
If the equipment is used in a manner not specified by the manufacturer, any protection provided by
•
the equipment may be impaired.
Modification of switchgear is outside the scope of this document. Adhere to all regulatory and
•
manufacturer standards when considering modifications. Ensure that any such modifications do not
reduce structural integrity or arc flash withstand of the switchgear.
Do not use the SD card slot or the Ethernet port, these ports are currently not supported.
•
For application information email product-support@eatechnology.com.
•
Collector (CDC) range is for use only with specified equipment and cables supplied by
Page i