Table of Contents
Advertisement
3660-MANUL-V01.01.00-CDC3 Operating Manual
4.
Using the CDC Software
Connect the CDC to a PC using the supplied USB cable.
Run software located in Start > Programs > EA Technology > CDC
4.1
Software Initialisation
When the main interface has started, the software will attempt to find the attached CDC. During this
process, a message (Figure 16) will appear. The window will close once the CDC has been detected.
This should take no more than 5 seconds. If problems detecting the CDC occur, a warning message will appear
(Figure 17). This error should only occur if the CDC is not connected correctly, check USB cable is securely
connected, and click Yes.
On some laptops, not all USB ports will function correctly, try connecting CDC to a different USB port if the error
persists. If the error message persists and the cable and laptop have been ruled out as the source of the
problem, contact EA Technology for further assistance.
If during loading procedures, it has not been possible to read asset data, a warning will be displayed ( Figure
18). If a warning is displayed, try unplugging the CDC and closing the software, re-connect the CDC and start
the software again. If the warning message persists, please contact product support.
It is still possible to capture data without the asset data, however this is not advised as the results of the
analysis may have reduced accuracy.
Figure 16
Looking for instrument at software start-up
Figure 17
CableData
®
Figure 18
Error whilst reading asset data
Collector Software Start-up
Page 10 of 30
Advertisement
Table of Contents
