Table of Contents
Advertisement
Available languages
Available languages
Free Standing Instructions
1. Place the free standing feet on the ground, keep the slots of both foot inline, distance
the foot which is on the switch side at least 12cm and similar distance the other, and insert
the panel into the slots lightly.
2. Screw the two bolts into the holes on the feet.
Operating Instructions
Use and Working
1. Check the heater to be sure it is not damaged.
2. Insert the plug in the socket
3. Press the
button: the heater will start working. The display will show the room
temperature.
4. After use, press the
button first in order to switch the device off. Finally remove the
plug from the socket.
Thermostat:
1. If you press the + or - key, the temperature setting will flash 5x on the display.
2. You can adjust the temperature setting by pressing the + or - key while it is flashing.
With each key press, the temperature will be increased (+) or decreased (-) by one
degree.
3. The device will retain the temperature setting by switching itself on and off
automatically.
Timer :
Briefly pressing once on the M button will switch the timer on. You can set the time when
the heater is to switch itself off by pressing the + or - buttons: with each press it will go an
hour forwards or backwards. The timer time is set after 5x unchanged blinking. The display
will now alternately show the room temperature and the set number of hours. The heater
will switch itself off after the set number of hours.
REMOTE CONTROL ：
The remote allows the same functions to be controlled as the main
control panel on the air cooler.
10/12
Advertisement
Table of Contents
