Remote Control Instructions - MALTEC CARBON770W-PRO WiFi Instruction Manual

Remote control instructions

RC1 - "+" increase temperature
RC2 - Screen Off
RC3 - "T" Timer
RC4 - "-" decrease temperature
RC5 - ON/OFF
RC6 - Child Lock
RC7 - ECO mode
RC2: Press to screen off, press again to screen on.
RC6: Press to lock, the icon will be light on, then all the keys on the control panel or on the
remote control will be unavailable; Press again to unlock.
RC7: Press to turn on the ECO mode, the icon will be light on, When the room
temperature drops more than 5 degrees in 1 minute, the heater will automatically stops
heating to save energy; Then you need to restart the heater to turn on the unit.
NOTE: Before using the remote control, make sure that 2 pieces of AAA battery are
installed correctly.
Operating instructions
There are two modes to use this heater
I. Simply Heating ON/OFF mode with 24 hours timer
1. Check the heater to be sure it is not damaged before using.
2. Insert the plug in the socket;
3. Turn the main switch on, you will hear "beep", the big display screen will be light on,
then display "--", WIFI light flashing and the heater is in standby mode;
4. Press "ON/OFF" key, the display screen will show the room temperature. The
default setting temperature is 25°C, the unit will start heating when the room
temperature is lower than 25°C, the heating icon will be light on; the unit will only
show room temperature without heating when the room temperature is higher than
25°C.
5. Press the "up" or "down" key to adjust the temperature setting, it will flash 5seconds
on the display to confirm the setting temperature , then back to room temperature
display. With each key press, the temperature will be increased (+) or decreased (-)
by one degree.
17/34