For Emergency; Alarm Display; Switching "Normal Display" And "Alarm Display; Switching From "Normal Display Screen" To "Alarm Display Mode - Mitsubishi Heavy Industries TU1250SAE Operation Manual

9 For emergency

9 For emergency

Alarm display

Alarm display
● When any trouble occurs, the warning icon
●If any error occurs, the abnor-
lights (backlight blinks) or blinks.
mal display
● Check the alarm code displayed in the
on the LCD (the backlight lights
digital display area.
or blinks).
When no alarm codes are displayed in the
●Check the alarm code displayed
digital display area, switch the screen to
at the right-hand side of the
the "Current alarm display" manually in
abnormal display. (If it is a light
the following procedure, and check the
error, the alarm content at the
contents.
right-hand side of the alarm code is not displayed.)
When no error code is displayed at the LCD, change to the alarm display as
described below, and check the alarm content.
Switching "Normal display" and "Current alarm display"

Switching "Normal display" and "Alarm display"

Switching from "Normal display screen" to "Alarm display mode"

Press once each on the [MENU] switch, [F3( )] switch and [F4(Select)] switch.
(The display returns to the "Normal display screen" 20 seconds later.)

Switching from "Alarm display mode" to "Normal display screen"

Press the [F1(Back)] switch 2 times on the extended display of "Alarm display
mode". (The screen changes to "Normal display screen" in 20 seconds in case
of 1 press.) or hold down [MENU] switch.
lights or blinks
Alarm
R U N / S T O P
E010
E016
E013
D E FR O S T
Back
P R E S E T
F1
Abnormal display
Alarm code
E010 HP Abnormally high
-
16 Jan 2019 07:10
15 Jan 2019 08:15
30 Nov 2018 10:30
Clear
F2 F3 F4
- 53 -
- 71 -
4 初期設定
Alarm content
Set
20 .
7
° C
- 30
M E N U
1
2
.
0
° C
3
4
5
6
7