Fuel Circulation Mode Setting - Mitsubishi Heavy Industries TU1250SAE Operation Manual

4 初期設定
燃料循環方法 （エア抜きモード）

Fuel circulation mode setting

R U N / S T O P
P R E S E T
1
Press "MENU" switch.
⇒
The display changes to "Main menu" screen.
2
Press "F2 (▲)" or "F3 (▼)" switch
till the display changes to
"Sub-menu" screen (Right gure).
3
Press "F4 (Select)" switch to
change to "Sub-menu" screen.
Press "F2 (▲)" or "F3 (▼)"
switch till the display changes to
"Fuel circulation mode" screen
(Right figure).
4
Press "F4 (Select)" switch to
change to "Fuel circulation
mode" screen (Right gure).
5
Press "F2 (ON)" switch.
⇒ The remaining time (in minute) is
displayed. Fuel circulation is
completed 10 minutes later and
the display returns to the normal
display screen. To interrupt the fuel circulation, press "F3 (OFF)" switch to
return to "Fuel circulation mode" screen of Step 4.
NOTE
◦ If fuel is used up, air may intrude in the fuel system such as the fuel hose, etc, so that the engine may
become unable to start. In such occasion, purge air in the fuel circulation mode before starting engine.
uel circulation mo e
O
D E FR O S T
F1 F2
2・3・5 3・4
- 00 -
- 36 -
emaining time min
OFF
F3 F4
Main menu
▲ anguage
Su -menu
▼ Operating information
Back ▲
F1 F2
Su -menu
Controller soun setting
▲
uel circulation mo e
▼ Calen ar an clock setting
Back ▲
F1 F2
uel circulation mo e
O
Back O
F1 F2
uel circulation mo e
O
F1 F2
4 Initial setting
1
M E N U
▼ Select
F3 F4
▼ Select
F3 F4
F3 F4
emaining time min
O
F3 F4
1
2
3
4
5
6
7
8
9
1 0