Cisco CIVS-IPC-2500 User Manual page 49

Chapter 3 Configuring and Managing the IP Camera
If you change any options in the PTZ (RS-485) window, you must click Save to save the changes. To
discard the changes, click Cancel before clicking Save. These buttons appear at the bottom of the
window. You may need to scroll down to see them.
Table 3-18
These features are not currently supported if you use the IP camera with Cisco VSM.
Note
Table 3-18
Option
Enable External PTZ
Port Settings
Baud Rate
Data Bits
Parity
Stop Bits
Address
Preset Position
Note
Set Preset Position
OL-14220-01
describes the options in the PTZ (RS-485) window.
PTZ (RS-485) Window Options
Description
Check this check box to enable configuration of the PTZ settings.
Choose the Baud rate value that is configured on the device that controls the
PTZ functions of the IP camera.
Choose the data bits value that is configured on the device that controls the
PTZ functions of the IP camera.
Choose the parity value that is configured on the device that controls the PTZ
functions of the IP camera.
Choose the stop bits value that is configured on the device that controls the
PTZ functions of the IP camera.
Enter the logical address of the external PTZ device.
To determine this address, refer to the documentation for that device.
The Preset Position option appears if you check the Enable External PTZ check box.
Click the Set Preset Position button to define a preset position of the IP
camera.
When you click this button, the Set Pan/Tilt window appears. For detailed
information about this window, see the
on page 3-30.
Cisco Video Surveillance System IP Camera User Guide
Applications Windows
"Preset Positions Window" section
3-29