MTI RAPIDDOC PRO KIOSK Installation Manual page 11

FCC Statement
Federal Communication Commission interference statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures: -Reorient or relocate the receiving
antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into
an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an
experienced radio/TV technician for help.
FCC Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including interference that may cause undesired
operation
RF Exposure Warning
The equipment complies with RF exposure limits set forth for an uncontrolled environment. The
antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
You are cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
Technical Data:
Operating Temperature 0 - 40 °C
Si le kiosque n'est pas monté sur un comptoir ou une table, il peut tomber, causant des dommages au
kiosque ou à une personne. De plus, les câbles USB peuvent être déconnectés lorsqu'ils se déplacent
sur une surface. Voir la page 3 des instructions de montage.
L'équipement convient uniquement pour un montage à des hauteurs <2 mètres.
La plaque signalétique appliquée est située au bas du produit.
Utilisez uniquement une alimentation 185-00282 avec des puissances de sortie 24VDC max., 2,7 A
max, PS2 ou LPS
La prise de courant (adaptateur secteur) doit être installée près de l'ÉQUIPEMENT et doit être
facilement accessible.
www.MTIGS.com | T:801.653.3807
-CONTROLLED DOCUMENT- 063-00180 E-0 Status: Approved
®
PRO KIOSK INSTALLATION GUIDE
RAPIDDOC
MTI P/N 063-00180 rev E ©2021 MTI All Rights Reserved
ECO-112676
11