Required Hardware - Syntacore SCR1 SDK Quick Start Manual

1. Required Hardware

Minimal set of hardware needed for SCR1 SDK, Arty Edition, includes just the following
components:
• Digilent's Arty FPGA Development Board
https://reference.digilentinc.com/reference/programmable-logic/arty/start
• Standard USB Type A (m) - Type B micro (m) cable
The minimal setup is shown in
If you are going to debug software running on the SCR1 with GDB/OpenOCD, you need also
• JTAG Cable Adapter: Olimex ARM-USB-OCD-H (or ARM-USB-OCD)
https://www.olimex.com/Products/ARM/JTAG/ARM-USB-OCD-H/
• Standard USB Type A (m) - Type B (m) cable
• Wire Connection between JTAG Cable Adapter and JD PMod connector on the Arty board. This
could be done in different ways. Possible variants are
◦ Small prototype board with connectors for standard 20-wire ARM JTAG flat ribbon cable,
and for JD PMod. Example of this approach is shown below in
◦ Male-to-Female Jumper Wires. The wires, e.g., might be of the following type:
https://www.adafruit.com/product/826
4
Figure 1.
Figure 2.