Table of Contents
Advertisement
Installing your gas cooker
Bringing it all together
Gas pipe
Seal
Mechanical gas
hose
Mechaniccal
gas hose
Mechanical
gas hose
The Cooker must be installed and maintained by
a suitably qualified gas registered technician in
accordance with current safety legislation.
WARNING: Do not use a naked flame to check for
gas leaks.
Gas conversion
Your appliance is designed to be operated with LPG/
NG gas. The gas burners can be adapted to different
types of gas, by replacing the corresponding injectors
and adjusting the minimum flame length suitable to the
gas in use. For this purpose, the following steps should
be performed:
Changing injectors
Hob burners
• Cut off the main gas supply and unplug the
appliance from the mains electrical supply.
• Remove the burner caps and the adapters.
• Use a 7 mm spanner to unscrew the injectors.
• Replace the injector with the ones from the gas
conversion kit, with the correct diameters for the
type of gas that is going to be used, according to
the gas injector table.
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 257 7271.
Burner cap
Adapter
Cup
Spanner
Adapter
Oven/Grill (if available) Injectors
The oven and grill injectors are held in position by a
single screw on the tip of the burner.
For oven burners, open the drawer compartment and
locate the assembly screw below the burner. Remove
the screw, move the burner diagonally and the injector
will be revealed on the rear side of the burner box.
For grill burners, the screw is already visible. Remove
the screw, pull the grill burner towards you and the
injector will be visible on the rear surface of the oven
cavity.
Oven burner
Injector
Installing your gas cooker
19
Advertisement
Table of Contents
