Table of Contents
Advertisement
I N S TA L L AT I O N
D o o r c o n v e r s i o n f o r m o d e l s w i t h s i d e o p e n i n g d o o r s
Side opening door models can be converted from left hand opening (as delivered) to right hand
opening. It is recommended that the installer complete the door conversion, at the time of
installation. To do this, use the following instructions:
• Open the door fully so access to the top hinge bracket can be had with a Philip's head
screwdriver.
• Whilst ensuring that the weight of the door is supported, unscrew the two screws at "A" on
the top hinge bracket.
• Tilt the door slightly away from the appliance and the door can now be lifted off the bottom
hinge bracket.
• Place the door down on a safe and stable surface and ensure that the top bracket is also placed
in a safe place.
• The door has two pivot pins and washers beneath each hinge bracket. Ensure these are not lost,
as they will be needed to reassemble the door.
• Remove the two screws at "C" on bottom hinge bracket.
• Remove the plastic plug on the front frame at "B" and also remove the insert from the opposite
side. Then reverse these and insert them in the holes of the front frame. Note: to remove the
two plugs a small flat bladed screwdriver will be needed.
• The top hinge bracket can now be screwed to the bottom hinge position on the opposite side.
Using the two screws previously removed, insert and securely tighten.
• The oven door is symmetrical and is now rotated 180 degrees so the handle is on the opposite
side. The door is now ready to be refitted.
• Ensure that the pivot pins and washers are in place and also place the bracket previously
removed from "C" on the top hinge bracket of the oven door.
• Position the door bottom pivot pin into the bottom hinge bracket and tilt the door back
towards the appliance so the top bracket is aligned with the mounting holes.
• Whilst supporting the weight of the oven door insert the two remaining screws and tighten.
• Check carefully that the oven door can be closed and opened and is operating correctly.
• Lastly, insert the square plastic trims (in the same bag as this book) into the hinge brackets at
"D".
35
Advertisement
Table of Contents
