Using Your Tape Blade; Power-On Of Tape Blade; Power-Off Of Tape Blade - NEC Express5800 Series User Manual

USING YOUR TAPE BLADE

This section describes the basic operation of the Tape Blade.
The power of the Tape Blade is automatically controlled in linkage with the power of CPU blade. Refer to
the manual that comes with your CPU blade for power on/off of the Tape Blade.

Power-on of Tape Blade

The power of the Tape Blade is automatically controlled in linkage with the power of the connected CPU
blade. Refer to the manual that comes with your CPU blade to power on the Tape Blade.
IMPORTANT:
the use of the POWER switch or the remote power-on after the period of 30
seconds or longer has passed from the supply of AC power to CPU blade and
Tape Blade. The POWER lamps on CPU blade and Tape Blade goes on amber
if they are powered on. The power-on operation within the period of 30
seconds from the supply of AC power to them may not turn on the power of
the CPU blade. If so, turn on the power of the CPU blade by using the
POWER switch after making sure that the AC power is supplied to CPU blade
and Tape Blade.
NOTE:
controller including an uninterruptible power supply (UPS), make sure that the
power of the power controller is turned on.

Power-off of Tape Blade

The power of the Tape Blade is automatically controlled in linkage with the power of the connected CPU
blade. Refer to the manual that comes with your CPU blade to power off the Tape Blade.
Perform the power-on operation of the CPU blade by either
If a power cord on the Blade Enclosure is connected to a power
General Description 2-13