Esc Programming Via Switch Push Button - Spektrum Firma SPMXSE1070 Manual

ESC Programming via Switch Push Button

1. Power ON your transmitter. Connect a battery to the ESC and
power it ON.
NOTICE: The transmitter and receiver must be connected.
2. Press and hold the programming button for 1 second.
OPTIONAL: Press and hold the programming button for 5
seconds to reset all ESC programming options.
3. Release the programming button. The red LED will blink to
indicate it has entered programming mode
4. The red LED blinks (and the motor beeps) to indicate the pro-
gramming item. Press the programming button for 1 second in
order to toggle through the programmable items.
• 1 red LED blink for item one, 2 red LED blinks for item
2, etc.
• Items 5 and above: 1 long LED blink for item 5, 1 long
LED blink and 1 short LED blink for item 6, etc.
• Items 10 and above: 2 long LED blinks for item 10, 2 long
LED blinks and 1 short LED blink for item 11, etc.
5. Press and hold the programing button for 3 seconds when you
want to enter a programming item.
6. The LED blinks to indicate the programming value within the
item selection.
7. Press and hold the programming button for 3 seconds when
you want to select a programming value.
8. Power off the ESC.
9. Begin the process again to change any other programming
values. One long LED blink and one long beep will indicate
when the ESC is ready to run.
12