Basic Recording - JVC GR-SXM460A Instructions Manual

16
EN
LENS COVER Open/Close Ring
Recording Start/Stop Button
2 5M I N
MIN 120MIN
(Now calculating)
0MIN 1MIN
(Blinking) (Blinking)
90°
180°
Select Wheel (BRIGHT)
–
– – – – – – – – – –
BR I GHT 6
To Adjust The Brightness Of The LCD Monitor
.... rotate the Select Wheel (BRIGHT) until the
bright level indicator on the display moves
and the appropriate brightness is reached.
AUTO : Suitable for standard recording using NO special effects or manual adjustments.
PRO. : Allows you to set recording functions using the menus for more creative capabilities.
OFF : Switches off the camcorder.
PLAY : Allows you to play back your recordings.
Power Switch
Tape remaining time
indicator
(Approximate)
119MIN
2MIN 3MIN
(Blinking)
DISPLAY Button
+
Power Switch Position
RECORDING
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
● Power (
pg. 6)
● Recording Mode Setting (
● Tape Length Setting (
● Load A Cassette (
● Grip Adjustment (
● Viewfinder Adjustment (
Shooting While Watching The Viewfinder
1
Make sure the LCD monitor is closed and locked
(GR-SXM460A/SXM260A/SXM46EA/SXM26EA only).
Turn the LENS COVER Open/Close Ring to open the
lens cover. Set the Power Switch to "CAMERA"
("AUTO" or "PRO."). The power lamp lights and the
camcorder enters the Record-Standby mode.
"PAUSE" is displayed in the viewfinder.
2
Press the Recording Start/Stop Button. "
in the viewfinder while recording is in progress.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.
Shooting While Watching The LCD Monitor
(GR-SXM460A/SXM260A/SXM46EA/
SXM26EA only)
1
Make sure the LCD monitor is fully open. Turn the
LENS COVER Open/Close Ring to open the lens
cover. Set the Power Switch to "CAMERA" ("AUTO"
or "PRO."). The power lamp lights and the
camcorder enters the Record-Standby mode.
"PAUSE" is displayed in the LCD monitor.
2
Tilt the LCD monitor upward/downward for best
viewability and press the Recording Start/Stop Button.
" " appears in the LCD monitor while recording is
in progress.
NOTE:
When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, use the viewfinder instead.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.

Basic Recording

pg. 10)
pg. 10)
pg. 11)
pg. 14)
pg. 14)
" appears