Audio Dubbing - JVC GR-SXM460A Instructions Manual

Compact vhs camcorder
Hide thumbs Also See for GR-SXM460A:
Table of Contents

Advertisement

Display
e
4
M – 0 : 0 5 :
2
0
Remote sensor
REW
A.DUB
PLAY
PAUSE
STOP
RM-V716U
OR
(provided with
GR-SXM460A/
SXM46EA only)

Audio dubbing

indicator
During Audio
Dubbing
Microphone
RM-V700U
(optional)
Audio Dubbing
You can record a new soundtrack on a prerecorded tape.
The existing original sound is erased and replaced by the
sound from the built-in microphone.
Perform steps 1, 2 and 3 of the Insert Editing procedure
(
pg. 42) before continuing.
NOTE:
Use the remote control unit to perform the following
procedures.
1
Press REW (2) to go a little beyond the beginning of
the scene onto which you want to dub the new
audio, press PLAY (4) to view the recorded tape, then
press PAUSE (6) at exactly the point where dubbing
should start.
2
Press and hold A. DUB (e), and without releasing
A. DUB (e), press and release PAUSE (6). The Audio
Dub-Standby mode is engaged.
3
To begin Audio Dubbing, press PLAY (4). When the
counter reaches "0:00:00", Audio Dubbing stops
automatically and the camcorder enters the Audio
Dub-Standby mode.
4
To end Audio Dubbing, press STOP (5).
NOTES:
● Do not press FF ( 3 ) or REW ( 2 ) during Audio Dub-
Standby, or the edit points will not be accurate.
● If the microphone is too close to the TV, or if the TV's
volume is too high, whistling or howling may occur.
NOTES
(for Insert Editing and Audio Dubbing):
● Insert Editing and Audio Dubbing may not work
correctly if the tape contains blank segments, or if the
recording speed was changed during the original
recording.
● To edit/dub onto a tape, make sure the Erase Protection
tab is in the position that allows recording. If not, slide
the tab. Some cassettes have removable tabs. If the tab
has been removed, cover the hole with adhesive tape.
● Do not press STOP ( 5 ) during Insert Editing or Audio
Dubbing, or the edit points will not be accurate.
● During Insert Editing and Audio Dubbing, when Insert-
Pause or Audio Dub-Standby is engaged, the counter
may go slightly past "0:00:00". Recording, however,
stops at exactly 0:00:00.
43
EN

Advertisement

Table of Contents
loading

Table of Contents