Table of Contents
Advertisement
14
Downloaded from:
https://www.usersmanualguide.com/
LENS COVER
SWITCH
POWER
Start/Stop
The power indicator
Tape remaining time
indicator
120MIN
119MIN
1MIN (Blinking)
2MIN (Blinking)
0MIN (Blinking)
*
MIN.....(Now calculating)
Tally lamp
RECORDING
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
● Power (
pg. 8)
● Tape Length/Recording Mode Setting (
● Grip Adjustment (
LOAD A CASSETTE
1
Slide EJECT to open the cassette holder, then insert
the cassette with the label facing out. Press PUSH to
ensure the holder is closed and locked.
ENTER RECORD–STANDBY MODE
2
Slide the LENS COVER open/close switch to open
the lens cover, then set the power switch to
CAMERA.
•The power indicator lights and the camcorder
enters the Record–Standby Mode.
•The scene you're aimed at appears on the
viewfinder screen, with the word "PAUSE"
superimposed upon it.
START SHOOTING
3
Press the Recording Start/Stop button.
•The tally lamp lights while recording is in progress,
REC
and "
" appears in the viewfinder.
3MIN
STOP RECORDING
4
Press the Recording Start/Stop button again to stop
recording.
•The camcorder re-enters the Record-Standby
mode.
NOTES:
● A cassette holder can't be opened unless a power
supply is attached.
● There may be a delay after you slide EJECT until the
holder opens. Do not use force.
● The tape's remaining time is displayed in the
viewfinder as shown.
● "TAPE END" appears when the tape reaches its end,
and the power goes off automatically if left in this
condition for 5 minutes. "TAPE END" also appears
when a cassette whose tape is already at its end is
loaded.
● If the Record–Standby mode continues for 5 minutes,
the camcorder's power shuts off automatically. Set the
power switch to POWER OFF, and then back to
CAMERA to turn the camcorder on again.
● If you're recording on a cassette from the middle, use
the RETAKE function (
last recording so you don't erase any of it.
● The LENS COVER warning blinks for about 5 seconds
when the camcorder is turned on, whether the cover is
open or closed.
Basic Recording
pg. 11)
pg. 12)
pg. 15) to find the end of the
Advertisement
Table of Contents
