Table of Contents
Advertisement
Oven Door Removal
For ease of installation, remove oven door(s) before placing
unit into cutout. This will reduce the weight of the unit by
about 35 pounds per door. Remove the oven door as
follows:
•
Open oven door to the "Full Open" position (see Figure
1).
•
Rotate hinge locking lever DOWN, to unlock hinge from
the unit (see Figure 2).
•
Close oven door to the "Removal" position (until it stops;
see Figure 3).
•
Grasp the door firmly on each side and lift the door
straight up and off the unit.
NOTE: The oven door is heavy. Be sure you have a firm grip
before lifting the oven door off the unit.
Do not lift the door by the handle!
Hinge Locking Lever
(Locked Position)
Figure 1
Hinge Locking Lever
(Unlocked Position)
Figure 2
Figure 3
Oven Door Replacement
Replace oven door after placing unit into cutout. Replace
oven door as follows:
•
Grasp oven door firmly on each side, hold oven door
at approximately a 30° angle and align oven door
hinge arm (see Figure 4) with hinge receiver on unit (see
Figure 5).
•
Insert oven door hinge arm into hinge receiver until the
hinge arm slots (see Figure 4) align with horizontal pins
on the hinge receiver (see Figure 5) and place hinge
arm onto the hinge receiver.
•
Once the hinge arms are resting on the hinge receiver
pins (see Figure 3) open oven door slowly to the "Full
Open" position (see Figure 2).
•
Rotate hinge locking lever UP to the locked position to
secure the oven door to the unit (see Figure 1).
NOTE: Make sure that hinge locking lever is rotated fully UP
to the locked position as shown (see Figure 1) before closing
oven door.
CAUTION
Door will not close all the way and could fall off when
opened if the hinge locking levers are not rotated fully UP
to the locked position.
If hinge locking lever will not rotate fully UP to the locked
position as shown (see Figure 1) then the hinge arm is not
properly seated on the receiver. Rotate the hinge locking
lever DOWN to the unlocked position (see Figure 2) and
remove oven door as outlined in the Oven Door Removal
procedure. Then replace the oven door as outlined in the
Oven Door Replacement procedure, making sure that the
hinge arm slots are fully seated on the horizontal pins in the
hinge receiver.
•
Once the hinge locking lever is rotated fully UP to the
locked position (see Figure 1) close the oven door.
Hinge Arm Slots
9
Classic 9800
Hinge Arm
Figure 4
Hinge Receiver
Horizontal Pins
Figure 5
Advertisement
Table of Contents
