Schedule With Time Picker - Hawking Net-Vision HNC700PT User Manual

4.3.2 Schedule with Time Picker

4.3.2.1 Begin and End Time
Day picker
There are three controlling units in both "Begin Time" and "End Time" selectors, as
shown in Figure 4-8. The first part of each of these two selectors is the Day Picker.
You can select the day of the week with it and set the beginning time and the ending
time for the recording interval.
The second and third units are the Hour Picker and the Minute Picker. You can
change the hour and minute settings for the beginning and ending time with them.
NOTE: Normally, the time set in "Begin time" must be earlier than that in "End
time". But if this is not the case, it means the time is over two days.
4.3.2.2 Add and Erase Buttons
After you have selected the time period with the "Begin time" and "End time"
pickers, you can apply the period picker, shown in Figure 4-9 and set the type of
time interval that associates with the beginning and end time. After having the
settings in "Begin Time", "End Time" and "Period Picker" done, click on the
"Apply" button to confirm the settings. Click on the "Erase" button to clear all
scheduling information just entered. All newly entered scheduling time interval
information will take effect only after the "Apply" button has been clicked.
Management & Control Software User's Manual
Hour picker
Figure 4-8 Begin Time and End Time Selectors
4-53 - –
Minute picker