Troubleshooting The Firmware Package Installation - Cisco SCE 1000 2xGBE Installation And Configuration Manual

Problem Solving Using a Subsystems Approach
Table 8-4
LED Label
IN
OK
Power A/B (front panel)

Troubleshooting the Firmware Package Installation

Check the following to help isolate a problem in the installation of the firmware package.
Problems related to the installation of the firmware package could be any of the following:
•
•
•
Cisco SCE 1000 2xGBE Installation and Configuration Guide
8-10
Faulty power supply.
Power Supply LEDs
File not found in the expected location
Wrong file type.
Device to which the file is to be extracted is full.
If the system still fails to come up when the
power supply is connected to a different power
source with a new power cable, the power
supply unit is probably faulty. Contact a service
representative.
Color State
Green On
Off
Green On
Off
Green Steady
Red Steady
Off
Chapter 8
Function
The input voltage is in the required range.
The input voltage is not in the required
range.
The output voltage is in the required range
(between 11.9 and 12.1 VDC).
The output voltage is not within the
required range (is greater than 12.1 VDC or
less than 11.9 VDC).
Corresponding power supply unit is present
and functioning normally.
Corresponding power supply unit present,
but malfunctioning.
Corresponding power supply unit is either
not present or has failed.
Troubleshooting
OL-7821-05