Step 7: Configuring Access Control Lists (Acls) - Cisco SCE 1000 2xGBE Installation And Configuration Manual

Initial System Configuration
Type y and press Enter.
The RDR-formatter destination dialog begins.
Step 2 Type the IP address of the RDR-formatter destination and press Enter.
Note that there is no default for this parameter.
Type the TCP port number of the RDR-formatter destination and press Enter.
Step 3
Note that there is no default for this parameter.
Enter RDR-formatter destination's TCP port number:
E
XAMPLE
Following is a sample RDR-formatter configuration dialog, assigning the IP address and TCP port
number.
Would you like to enter the RDR-formatter configuration menu? [no]: y
Enter RDR-formatter destination's IP address: 10.1.1.230
Enter RDR-formatter destination's TCP port number: 33000

Step 7: Configuring Access Control Lists (ACLs)

The SCE 1000 can be configured with Access Control Lists (ACLs), which are used to permit or
deny incoming connections on any of the management interfaces.
ACL #0 is a pre-defined list that permits access to all IP addresses.
Note
Configuration of access control lists is done in two stages:
Create the access control lists.
Step 1
You may create 99 ACLs with a maximum of 20 entries per list. Each entry consists of an IP
address, and an indication of whether access is permitted or denied to this IP address.
Step 2 Assign the ACLs to the appropriate management interface. (See Step 9: Configuring the
Topology-Dependent Parameters (on page 5-19).)
The dialog permits you to skip the creation/editing of the ACLs and go directly to assigning ACLs
to the management interfaces.
Cisco SCE 1000 2xGBE Installation and Configuration Guide
5-12
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Would you like to enter the RDR-formatter configuration menu? [no]: y
Enter RDR-formatter destination's IP address:
:
OL-7821-05