Toshiba RAV-HM561KRTP-E Installation Manual page 27

Wiring between indoor unit and outdoor unit
1
Figure below shows the wiring connections between the indoor and outdoor units and
between the indoor units and remote controller. The wires indicated by the broken lines or
dot-and-dash lines are provided at the locally.
2
Refer to the both indoor and outdoor unit wiring diagrams.
3
The power of the indoor unit is supplied from the outdoor unit.
Wiring diagram
Single system
Remote controller
Remote controller wiring
A B
Indoor side
1
Indoor / Outdoor
connecting wires
1
Outdoor side
Power supply
Simultaneous triple and double twin system
Remote controller
Remote controller
wiring
Indoor side
Indoor / Outdoor
connecting wires
Outdoor side
* Use 2-core shield wire (MVVS 0.5 to 2.0 mm² or more) for the remote controller wiring in the
simultaneous twin, simultaneous triple and simultaneous double twin systems to prevent noise
problems. Be sure to connect both ends of the shield wire to earth leads.
* Connect earth wires for each indoor unit in the simultaneous twin, simultaneous triple and simultaneous
double twin systems.
Simultaneous twin system
Remote controller
Remote controller wiring
Indoor side
2 3
Indoor / Outdoor connecting
wires
2 3
Outdoor side
Remote
controller
inter-unit
wiring
A B A B
Indoor
side
1 2 3 1
Indoor power
1 2 3
inter-unit
wiring
Power supply
Triple
A B
1 2 3
1 2 3
Power supply
Remote Remote
controller controller
inter-unit inter-unit
wiring wiring
A B
Indoor
side
2 3 1 2 3
Indoor power
inter-unit wiring
Double twin
‒ 26 ‒
Installation Manual
Remote controller
inter-unit wiring
A B
Indoor
side
1 2 3
Indoor power
inter-unit wiring
A B
Indoor
side
1 2 3
Indoor power
inter-unit wiring
26-EN