Sony FCB-IX47 Instruction Manual page 14

FCB-IX47/IX47P
FCB-IX470/IX470P
FUNCTIONS
Memory (Position preset)
Using the position preset function, 6 sets of camera shooting conditions can be stored and recalled.
This function allows the desired zoom position, focus (auto, manual positions), white balance, shutter, bright control, iris,
gain, exposure compensation, back light compensation, and aperture to be set instantaneously without having to adjust them
each time. It also memorizes the settings for electronic zoom on/off, slow shutter auto/manual, 0 lx shot on/off, IR LED on/off.
Date, Time display
When used together with the display command, displays the date and time will be displayed on the video monitor.
Time difference is ±30 seconds monthly.
Backup
Backs up the contents memorized by the memory (position preset) function and the camera functions when the power is turned
OFF.
The backup switch can be switched as follows.
• INT side : Backs up for about 6 months when the internal battery is fully recharged.
(Full recharge by letting about 24 hours in power ON state.)
• OFF side : No back up. Set to this position at shipment.
(This setting is set when the power is turned ON the next time.)
• EXT side : Backs up by the external power supply input to the CN705 connector.
Power supply voltage : 3.1 V ± 0.2 V
Current consumption : 6 µA
Zoom position analog output
Zoom position analog signals can be output by the CN805 connector of the IF-71 board.
Slow shutter – Auto/Manual
When set to "Auto", controls so that the slow shutter is set automatically when the brightness drops. Effective only when the
AE mode is set to "Full Auto".
Set to "Slow Shutter Manual" at shipment.
12
Optical zoom position
Analog output
Output tolerance
Output pin
Digital zoom position
Analog output
Output tolerance
Output pin
×1 ×18
0 V 3.1 V
±10%
CN805, 12P
×1 ×4
0 V 3.1 V
±10%
CN805, 11P