Warnings - Dimplex DHW 250P Installation And Operating Instructions Manual

English

1. Warnings

1.1. Intended use
This device is only intended for use as specified by the
manufacturer. Any other use beyond that intended by
the manufacturer is prohibited. This requires the user
to abide by the relevant project planning documents.
Please refrain from tampering with or altering the de-
vice.
1.2. Important information
ATTENTION!
Read these installation and operating in-
structions before commissioning!
ATTENTION!
Work on the domestic hot water heat pump
is to be performed by qualified personnel
only! Observe accident prevention regula-
tions!
ATTENTION!
The device cover cannot be used for carrying
(the cover cannot withstand significant
forces).
ATTENTION!
Once the heat pump has been set up, the
guard plate must be removed!
ATTENTION!
The heat pump may only be transported in
upright position (see chapter "Transport").
ATTENTION!
When installing the on-site pipework, ensure
that the pipes are not contaminated (flush
pipes before connecting the domestic hot
water heat pump if necessary).
ATTENTION!
The domestic hot water heat pump must
only be operated when filled with water.
ATTENTION!
Disconnect the power supply before open-
ing the domestic hot water heat pump; pos-
sible fan coasting must be considered.
EN-4
ATTENTION!
Risk of injury caused by sharp-edged fins.
Fins must not be deformed or damaged!
ATTENTION!
Disconnect the power supply before open-
ing the device.
1.3. Regulations / safety notes
ATTENTION!
Read these installation and operating in-
structions before commissioning!
The domestic hot water heat pump is used exclusively
to heat water for domestic use and drinking water
within the specified operating temperature limits. The
heating of fluids other than domestic water is not per-
mitted. Technical regulations for domestic water in-
stallation are to be observed. The nominal pipe widths
for the on-site sanitary installation must be deter-
mined taking into account the building-specific re-
quirements and the valid directives and regulations.
Any necessary safety devices, such as pressure re-
ducing valves, must be installed according to the spe-
cific requirements.
The following are not permitted:
Operating the pump with solvent-based or explo-

sive exhaust air
The use of exhaust air containing grease, dust or

aerosols
Connecting extractor hoods to the ventilation sys-

tem
It is not permissible to install the device:
Outdoors

In rooms which are exposed to frost

In rooms subject to high humidity (e.g. bath-

rooms)
In rooms with air which is potentially explosive be-

cause of gases, vapours or dust
It is not permissible to operate the device
With an empty cylinder

During the construction phase of the building

The construction and design of the domestic hot
water heat pump complies with the relevant EU direc-
tives.
FD 0207
Warnings
www.dimplex.de