Assembly - Olympus BX3-SSU Instructions Manual

8 8
To ensure the performance, we recommend that you have your Olympus representative assemble and adjust
the scanning stage with ultrasonic.
8-1 Assembly Diagram
· When assembling the scanning stage with ultrasonic, make sure that all parts are free of dust and dirt and
CAUTION
perform the procedures cautiously.
· Connect only the designated modules. Connecting a non-designated module may cause malfunction.
· Be sure to set the main switches of the BX3-CBH/IX3-CBH and control box for BX3-SSU to "
connecting the cables.
The following diagram shows only the cable connections associated with the scanning stage with ultrasonic.
When connecting each connector, align the connector orientation correctly and insert the connector all the
way. If a connector is equipped with lock screws, always tighten them firmly.
Power cord
Downloaded from ManualsNet.com

ASSEMBLY

Slide holder
Stage clips
IX2-SCL
Scanning stage for
ultrasonic
BX3-SSU
Control box
(Provided with BX3-SSU)
Dedicated cable
(Provided with BX3-SSU)
search engine
Center plate with
25 mm hole
Center plate with
50 mm hole
IX-CP50
Control box
BX3-CBH/IX3-CBH
Interface cable
U-IFCBL200
One of
OUT1 to 5
XY controller
(Provided with BX3-SSU)
BX3-SSU
" (OFF) before
IX83P1ZF
IX83P2ZF
IX73P1F
IX73P2F
IX51WIF
Microscope frame
BX63F
Controller
U-MCZ
12