Dante Interface Card; Ravenna Interface Card - AVT MAGIC THipPro Hardware Manual

3.3.4

Dante Interface Card

The Ethernet interfaces P and S on the optional Dante® module are used to
connect the device to a Dante® network. 32 audio inputs/outputs can be connected
over IP to Dante or AES67 compatible audio equipment.
Pin assignment: Ethernet Interfaces Dante®
Socket: RJ-45
Pin Signal
1
RX/TX A P Pair A +
2 RX/TX A N Pair A -
3 RX/TX B P Pair B +
4 RX/TX C N Pair C +
5 RX/TX C P Pair C –
6 RX/TX B N Pair B -
7 RX/TX D P Pair D +
8 RX/TX D N Pair D -
3.3.5

Ravenna Interface Card

The Ethernet interfaces NIC1 and NIC2 on the optional Ravenna® module are used
to connect the device to a Ravenna® network. 32 audio inputs/outputs can be
connected over IP to Ravenna or AES67 audio equipment. AES67, SMPTE ST 2110-
30/31, ST 2022-2022-7 and NMOS are supported.
Pin assignment: Ethernet Interfaces Ravenna®
Socket: RJ-45
Pin Signal
1
RX/TX A P Pair A +
2 RX/TX A N Pair A -
3 RX/TX B P Pair B +
4
RX/TX C N Pair C +
5 RX/TX C P Pair C –
6 RX/TX B N Pair B -
7 RX/TX D P Pair D +
8 RX/TX D N Pair D -
Electrical characteristics
Recommendation: IEEE 802.3/Ethernet
Data rate (Auto neg.): 100/1000 Mbit/s
Recommended cable: CAT5e or higher
Max. cable length: 100m
Electrical characteristics
Recommendation: IEEE 802.3/Ethernet
Data rate (Auto neg.): 100/1000 Mbit/s
Recommended cable: CAT5e or higher
Max. cable length: 100m
21