Installing Brackets On The Rear Of The Chassis - Cisco Router 7204 Installation And Configuration Manual

Chapter 3 Installing the Cisco 7204
If you aligned the first rack-mount bracket and cable-management bracket to the right side of the chassis,
Step 3
thread two M4 x 8-mm Phillips flathead screws through both brackets and into the side of the chassis.
Use a number 2 Phillips screwdriver to tighten the screws. (Refer to
If you aligned only the first rack-mount bracket to the right side of the chassis, thread two M4 x 8-mm
Phillips flathead screws through the bracket into the side of the chassis and use a number 2 Phillips
screwdriver to tighten the screws. Then align the first cable-management bracket to the rack-mount
bracket and thread two M4 x 8-mm Phillips flathead screws through the two brackets. Use a number 2
Phillips screwdriver to tighten the screws. (Refer to
Step 4 Repeat Step 1 through Step 3 for the other cable-management bracket (if required) and rack-mount
bracket.
This completes the procedure for installing the rack-mount and cable-management brackets on a
Cisco 7204 for a front rack-mount configuration.

Installing Brackets on the Rear of the Chassis

To install the rack-mount and cable-management brackets on a Cisco 7204 for a rear rack-mount
configuration, complete the following steps:
Locate the threaded holes in the rear sides of the chassis.
Step 1
Step 2 Align the first rack-mount bracket to the threaded holes in the right side of the chassis.
If you want the front of the chassis protruding out of the rack, align the rack-mount bracket to the chassis
as shown in
bracket to the chassis as shown in
Figure 3-8
Rack-mount
bracket
OL-5101-02
Figure 3-8. If you want the front of the chassis recessed in the rack, align the rack-mount
Figure
Installing the Rack-Mount Brackets on the Rear of the Chassis so the Front
Protrudes Out of the Rack
Figure 3-7.)
3-9.
SERIAL-EIA/TIA-232
Cable-management
bracket
Cisco 7204 Installation and Configuration Guide
Rack-Mounting the Cisco 7204
Figure 3-6.)
Cisco 7200
SERIES
ETHERNET-10BFL
FAST ETHERNET INPUT/OUTPUT CONTROLLER
3-7