Cisco Router 7204 Installation And Configuration Manual page 102

Troubleshooting Overview
–
–
–
Note
–
–
–
Cisco 7204 Installation and Configuration Guide
5-4
The IO power OK LED comes on immediately and indicates that the I/O controller is receiving
DC power from the router midplane. This LED comes on during a successful router boot and
remains on during normal operation of the router.
If this LED remains off when starting the router, either there is a problem with the power supply
(it is damaged or not connected to the router midplane), or the network processing engine or the
I/O controller are not connected to the router midplane. Proceed to the
Controller" section on page 5-6
The enabled LED comes on after the IO power OK LED and indicates that the network
processing engine and the I/O controller are enabled for operation by the system; however, it
does not mean that the Fast Ethernet port on the I/O controller is functional or enabled. This
LED comes on during a successful router boot and remains on during normal operation of the
router.
If this LED remains off when starting the router, it is probably a problem with the network
processing engine or the I/O controller (they are damaged or not connected to the router
midplane). Proceed to the
The FE enabled LED comes on after the enabled LED and indicates that the Fast Ethernet port
on the I/O controller is initialized and enabled for operation by the system. This LED comes on
during a successful router boot and remains on during normal operation of the router.
If this LED remains off when starting the router, it is probably a problem with the Fast Ethernet
port on the I/O controller. Proceed to the
page 5-6.
The I/O controller without the Fast Ethernet port does not have the FE enabled LED and the
FE link LED. The I/O controller without the Fast Ethernet port and the I/O controller that is
equipped with a single MII port do not have the MII enabled, RJ-45 enabled, and RJ-45 link
LEDs.
The FE link LED comes on only when the Fast Ethernet port on the I/O controller is receiving
a carrier signal from the network. This LED remains off during normal operation of the router
unless there is an incoming carrier signal, and does not indicate startup problems.
If this LED remains off when starting the router, it is probably a problem with the Fast Ethernet
port on the I/O controller. Proceed to the section
on page 5-6.
The MII enabled LED comes on after the enabled LED and indicates that the Fast Ethernet
port's MII port is initialized and enabled for operation by the system, and configured for
operation. This LED comes on during a successful router boot and after the MII port has been
configured as the media type for the Fast Ethernet port (the RJ-45 port is the default media type
for the Fast Ethernet port). This LED remains on during normal operation of the router.
If this LED remains off when starting the router, it is probably a problem with the Fast Ethernet
port on the I/O controller. Proceed to the section
on page 5-6.
The RJ-45 enabled LED comes on after the enabled LED and indicates that the Fast Ethernet
port's RJ-45 port (the default media type for the Fast Ethernet port) is initialized and enabled
for operation by the system. This LED comes on during a successful router boot and remains on
during normal operation of the router.
If this LED remains off when starting the router, it is probably a problem with the Fast Ethernet
port on the I/O controller. Proceed to the
page 5-6 .
later in this chapter.
"Troubleshooting the I/O Controller" section on page
"Troubleshooting the I/O Controller" section on
"Troubleshooting the I/O Controller" section
"Troubleshooting the I/O Controller" section
"Troubleshooting the I/O Controller" section on
Chapter 5 Troubleshooting the Installation
"Troubleshooting the I/O
5-6.
OL-5101-01