Connections For Cisco 3620, Cisco 3640, And Cisco 3631 Routers; Connections For Cisco 3660 Routers; Connecting Wan, Lan, And Voice Cables (Without Chassis Shield) - Cisco Router 3600 Hardware Installation Manual

Chapter 3 Installing the Router

Connections for Cisco 3620, Cisco 3640, and Cisco 3631 Routers

Connect each WAN, LAN, and voice cable to the appropriate connector on the chassis or on a network
module or interface card.
•
•
•
•
For cable pinouts, refer to the online document
For more information about connecting and configuring network modules, WAN interface cards, and
voice interface cards, refer to the following documents:
•
•

Connections for Cisco 3660 Routers

Connecting WAN, LAN, and Voice Cables (Without Chassis Shield)

If your Cisco 3660 router does not use a chassis shield, perform this procedure:
Connect each WAN, LAN, and voice cable to the appropriate connector on a network module or interface
Step 1
card.
Route the cables to the left side of the router, and organize the cables in bundles. (See
Step 2
•
•
Inspect the cables to make sure that the routing and bend radiuses are satisfactory. Reposition cables, if
Step 3
necessary.
Install cable ties in accordance with site requirements.
Step 4
OL-2056-05
Position the cables carefully, so that they do not put strain on the connectors.
Organize cables in bundles such that cables do not intertwine.
Inspect the cables to make sure that the routing and bend radiuses are satisfactory. Reposition cables,
if necessary.
Install cable ties in accordance with site requirements.
Cisco Network Modules Hardware Installation Guide
Cisco Interface Cards Hardware Installation Guide
Position the cables carefully, so that they do not put strain on the connectors.
Organize cables in bundles such that cables do not intertwine.
Connecting WAN, LAN, and Voice Cables
Cisco Modular Access Router Cable
Cisco 3600 Series Routers Hardware Installation Guide
Specifications.
Figure 3-53.)
3-39