Power-Up Procedure - Cisco Router 3600 Hardware Installation Manual

Powering Up the Router

Power-Up Procedure

To power up your Cisco router and verify that it goes through its initialization and self-test, follow this
procedure. When the procedure is finished, the Cisco router is ready to configure.
If you encounter problems when you power on the router, see
information about the ROM monitor and the bootstrap program, see
ROM Monitor."
Register."
To view the boot sequence through a terminal session, you must have a console connection to the Cisco
Note
router before it powers up.
Step 1 Make sure that your PC is powered up and connected as described in the
section on page
Step 2 Move the power switch to the ON position.
The following indications appear:
In Cisco 3620 series and Cisco 3640 series
•
•
In Cisco 3631
•
•
In Cisco 3660
•
•
Depending on your installation, Fast Ethernet (0/0, 0/1) and Network Module (Active, Ready) LEDs
might also come on.
If you encounter problems when you power up the router, see
Messages begin to appear in your terminal emulation program window.
Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are
Caution
interpreted as the first command typed when the messages stop, which might cause the router to power
off and start over. It takes a few minutes for the messages to stop.
You may see different startup messages:
•
Cisco 3600 Series Routers Hardware Installation Guide
3-52
For information about the configuration register, see
3-51.
The green LED next to the auxiliary port comes on.
The fan operates.
The green LED on the front of the chassis comes on.
The fan operates.
The LED on each power supply comes on.
The system and PS1 (and PS2) LEDs on the router front and rear panels come on.
If you see the following messages, the router has booted with a configuration file and is ready for
initial configuration using Security Device Manager (SDM).
yourname con0 is now available
Press RETURN to get started.
Chapter 3 Installing the Router
Appendix A, "Troubleshooting."
Appendix B, "Using the
Appendix C, "Configuration
"Checklist for Power Up"
Appendix A, "Troubleshooting."
For
OL-2056-05