Configuring The Router; Initial Configuration Using Sdm - Cisco Router 3600 Hardware Installation Manual

Chapter 3 Installing the Router
•
If the
Note
ROM monitor, see the router rebooting and ROM monitor information in the
Fundamentals Configuration Guide

Configuring the Router

You can configure your router by using one of the following tools:
•
•
•

Initial Configuration Using SDM

If Security Device Manager has been installed on your router, the following messages appear at the end
of the startup sequence:
yourname con0 is now available
Press RETURN to get started.
For configuration procedures using SDM, refer to the quick start guide that shipped with your router.
You can also access the
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis3600/36xx_qsg/index.htm
OL-2056-05
If SDM is installed on your router, Cisco recommends using SDM to perform the initial
configuration. For configuration procedures using SDM, refer to the quick start guide that shipped
with your router.
You can also access the Cisco 3600 series routers quick start guides
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis3600/36xx_qsg/index.htm
If you see the following messages, the router has booted and is ready for initial configuration using
the setup command facility or the command line interface (CLI).
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
To learn how to use the setup command facility to configure the router, see the
Using the Setup Command Facility" section on page
the router, see the "Initial Configuration Using the CLI (Manual Configuration)" section on
page 3-57.
prompt appears, your system has booted in ROM monitor mode. For information on the
rommon 1>
Security Device Manager. If your router was purchased with a VPN bundle, Security Device
Manager is installed on the router. See the
Setup command facility. you can use the setup command facility to prompt you for basic router
information. After the configuration file has been created, you can use the CLI or use Security
Device Manager to perform additional configuration. See the
Command Facility" section on page
Command-line interface (CLI). If you prefer to use the Cisco IOS CLI, see the
Using the CLI (Manual Configuration)" section on page 3-57
Cisco 3600 series routers quick start guides
3-54. To learn how to use the CLI to configure
for your Cisco IOS software release.
"Initial Configuration Using SDM" section on page 3-53
3-54.
Cisco 3600 Series Routers Hardware Installation Guide
Configuring the Router
online at:
"Initial Configuration
Cisco IOS Configuration
"Initial Configuration Using the Setup
"Initial Configuration
for instructions on how to use the CLI.
online at:
3-53