Tools And Equipment For Installation And Maintenance - Cisco Router 3600 Hardware Installation Manual

Tools and Equipment for Installation and Maintenance

Inspect all items for shipping damage. If anything appears to be damaged, or if you encounter problems
installing or configuring your router, contact customer service. Warranty, service, and support
information is in the quick start guide that shipped with your router.

Tools and Equipment for Installation and Maintenance

You need the following tools and equipment to install and upgrade the router and its components:
•
•
•
•
•
•
•
•
To install a Cisco 3620 router on a wall, you need suitable screws or wall anchors.
In addition, depending on the type of modules you plan to use, you might need the following equipment
to connect a port to an external network:
•
Note
•
•
•
•
•
•
•
Cisco 3600 Series Routers Hardware Installation Guide
2-8
ESD-preventive cord and wrist strap
Number 2 Phillips screwdriver
Flat-blade screwdrivers: small, 3/16-inch (0.476 cm) and medium, 1/4-inch (0.625 cm)
To install or remove modules
–
To remove the cover or mainboard tray, if you are upgrading memory or other components
–
Number 15 Torx screwdriver
For replacing components in the Cisco 3660 router
–
Rack-mount screws
ROM 32-pin PLCC extractor tool
Needlenose pliers
– For straightening any pins bent when you install the ROM
Cable ties, if required, for organizing cables
Cables for connection to the WAN and LAN ports (dependent on configuration).
For more information on cable specifications, refer to the
Specifications document online or on the Documentation CD-ROM.
Ethernet hub or PC with a network interface card for connection to Ethernet (LAN) ports.
Console terminal (an ASCII terminal or a PC running terminal emulation software) configured for
9600 baud, 8 data bits, no parity, and 2 stop bits.
Modem for connection to the auxiliary port for remote administrative access (optional).
Token Ring interfaces require a Token Ring media attachment unit (MAU).
Serial interfaces may require a data service unit (DSU) or channel service unit/data service unit
(CSU/DSU).
CT1/PRI modules without the built-in CSU require an external CSU.
ISDN BRI S/T interfaces require an NT1 device if one is not supplied by your service provider.
Chapter 2 Preparing to Install the Router
Cisco Modular Access Router Cable
OL-2056-05