Table of Contents
Advertisement
2. Connect the direct NVMe signal cables to the NVMe connectors on the processor and memory
expansion tray.
Figure 25. Connecting NVMe cables to the processor and memory expansion tray
Before starting cable routing for 2.5-inch drives:
1. Remove the fan cage assembly (see
2. Remove the processor and memory expansion tray and the expansion tray air baffle (see
processor and memory expansion tray" on page
Connecting power cable
Connect power cables for drive backplanes as in the following illustration.
Figure 26. Location of power cable connectors on the system board
Table 21. Power cable connectors on the system board and the drive backplanes
Power cable connector on the system board
1
Power cable connector on the system board
2
Two types of drive backplanes are supported by this system:
ThinkSystem SR850P Setup Guide
32
"Remove the fan cage assembly" on page
75).
Power cable connector on the drive backplane
3
Power cable connector on the drive backplane
4
77).
"Remove the
Advertisement
Table of Contents
